DIY iPad Case: A Stylish Solution for Only $1

This DIY iPad case started as a $1 find from the dollar store! I then decoupaged a leftover fabric scrap to the outside, turning it into a custom case.

Skills Required: Beginner. The only part that is a little tricky is cutting the holes and areas around the ports. Just work slowly and follow my instructions and you should be fine.

A recent trip to the dollar store revealed all sorts of new surfaces that I could decoupage. There is a new Dollar Tree in the area and they have some pretty good stuff! One of the goodies that caught my eye was a plastic iPad case for $1 (of course).

I wanted an iPad case and I have fabric stash, so the two came together to make this DIY iPad case. It’s so easy and would make a great gift. See how I made this lovely dollar store craft!

Gather These Supplies

• iPad case from Dollar Tree – they have a variety of sizes for whatever iPad you currently have!
• Fabric Mod Podge
• Satin Mod Podge
• Fabric of your choice – use a thin cotton
• Paintbrush
• Scissors
• Detail scissors (like the ones in the Mod Podge tool kit)
• Waxed paper
• Sandpaper

Keep in mind that Mod Podge makes fabric slightly transparent, so if the fabric isn’t very thick you’ll need to make sure that the iPad case is white (or matches the fabric) so that it doesn’t look crazy.

This is so easy – honestly I think this would make a great craft for kids OR adults! Get the printable how to below:

Save Saved! Print

4.50 from 2 votes

DIY Tablet Case

Learn how to make an iPad case using a dollar store find! It's easy to do with Mod Podge.

Prep Time15 minutes mins

Active Time45 minutes mins

Dry Time1 hour hr

Total Time2 hours hrs

Yield: 1 case

Cost: $1

Equipment

• Paintbrush(es)
• Scissors
• Detail scissors

Materials

• iPad case from Dollar Tree
• Mod Podge Fabric and Satin
• Fabric enough to cover the iPad case with a border around
• Wax paper
• Sandpaper

Instructions

• To prepare the fabric, paint a medium layer of Mod Podge on the fabric and let dry. Cover an area big enough to cover the iPad case.
  
• Place the iPad case on a support and lightly sand it so that the Mod Podge will adhere more easily. You just need to rough up the surface.
  
• Paint a layer of Mod Podge onto the case and smooth the fabric down on the top. Let dry.
  
• Tackling the edges takes some time. Make sure that folding over the fabric wouldn't affect the fit of the case, then paint the sides down.
  
• I used the detail scissors to trim around the ports and areas where parts of the iPad need to come through. The detail scissors are quite sharp so I also used them to poke the camera hole (then I folded the fabric back in this area).
  
• Let everything dry and then give it a few topcoats. Let dry completely before putting on your iPad.

Notes

I prepared my fabric using Fabric Mod Podge. I did this because I wanted a relatively durable and highly water resistant finish on the case, and Fabric Mod Podge does just that.

You might have to hold some areas of fabric for a minute or so until they attach, and you are probably going to have to cut the corners and fold them like a present to make them work.

Would you ever try a DIY tablet case of your own? I’d love to hear in the comments! I’d also love for you to check out the following projects:

• DIY Phone Case with Glitter in Four Easy Steps
• Cell Phone Holder from a Lotion Bottle
• Easy Back to School Crafts to Start the Year!
• DIY Phone Cases, Sleeves, Purses and More!