Go Back Email Link
Christmas tree mantel decor
Save Print
No ratings yet

Christmas Tree Mantel Decor

Decorate wood Christmas trees with napkins and faux snow for your holiday mantel! These are easy Christmas home decor.
Prep Time15 minutes
Active Time2 hours
Dry Time2 hours
Total Time4 hours 15 minutes
Yield: 2 trees
Cost: $25

Equipment

Materials

Instructions

  • Paint both unfinished wood trees with white craft paint. Use smaller brushes to get in between the slats. Don't forget the base. Give several coats and let dry.
    Painting an unfinished wood Christmas tree with white paint
  • Paint Mod Podge on the top of each slat. You don't need to get in between or on the edges. Let dry and paint a second coat. Let dry again.
    Painting a coat of Mod Podge on top of the white paint on the tree
  • Separate the layers from the napkin. You only want the top, printed layer. It helps to use double stick tape.
    Separating the layers of a holiday napkin
  • Place the napkin down onto the tree. Place a piece of parchment paper on top of the napkin, and run the craft iron across the top several times. While you are doing this, the Mod Podge is melting below the napkin, and the napkin is adhering. Keep going until the napkin is fully adhered.
    Ironing a holiday napkin down with parchment paper
  • Lift up and check under the parchment paper to see if you missed anywhere, especially around the edges. If you did, repeat the process from step 4.
    Holiday napkin on top of an unfinished wood tree
  • Let the tree cool after ironing. Use an emery board to gently sand away the excess napkin. Sanding at an angle works very well. Continue until all the extra napkin is removed.
    Sanding the edges of the holiday napkin with an emery board
  • Use a spray sealer to seal the napkin on top of the tree, if desired.
    Spraying the holiday napkin and tree with clear sealer
  • Apply the faux snow paint around the wood base. It helps to use a small spatula and pile it on. Keep going until you like the look, then let dry.
    Adding fake snow around the base of the tree
  • [mv_schema_meta name=""]Place the tree on its back. Use a brush to apply some of the faux snow paint where you would imagine branches to be. Get some of the edges and the top. Let dry.
    Adding fake snow on some of the edges of the tree
  • Use a paintbrush to apply Sparkle Mod Podge to the top of the dried faux snow. Let dry and display.
    Snow and sparkle Mod Podge detail